Products
Products
Contact Us
- 24-hour online service
- Own factory processing
E3F18-LT30M Laser through-beam Photoelectric Sensor
Uses a visible red laser beam between a separate emitter and receiver for non-contact object detection. The visible beam assists optical alignment during installation. Objects are detected by interrupting the beam, making this arrangement suitable for counting and presence detection across equipment openings. The M18 housing, pre-wired connection and operation indicator support installation and commissioning.
Technical Parameters
| Product Model | E3F18-LT30M | |||
| Output | NPN | NO | E3F18-LT30M-NO | |
| NC | E3F18-LT30M-NC | |||
| PNP | NO | E3F18-LT30M-PO | ||
| NC | E3F18-LT30M-PC | |||
| Housing Diameter | M18 | |||
| Sensing Method | Laser through-beam | |||
| Output Type | NPN/PNP | |||
| Sensing Distance | 30m | |||
| Sensing Object | Opaque object: diameter of 12 mm or greater | |||
| Differential Travel | 20% of sensing distance or less | |||
| Light Source (Wavelength) | Red laser (660 nm) | |||
| Power Supply Voltage | 12 to 24 V direct current; ripple: 10% maximum, peak-to-peak (10 to 30 V direct current) | |||
| Current Consumption | ≤45mA | |||
| Control Output | Load current: 100 mA maximum (residual voltage: 1 V maximum) | |||
| Response Time | Operate or reset: 1.0 ms maximum each | |||
| Protection Circuits | Surge protection, output short-circuit protection and reversed power supply polarity protection | |||
| Indicator | Operation indicator (red) | |||
| Ambient Temperature Range | Operating: -25 to +55 °C; Storage: -30 to +70 °C, with no icing | |||
| Ambient Illumination (Receiver Side) | Sunlight: 10000 lux maximum; incandescent lamp: 3000 lux maximum | |||
| Ambient Humidity Range | Operating: 45% to 85% relative humidity; Storage: 35% to 95% relative humidity, with no icing | |||
| Voltage Influence | Sensing distance changes by no more than ±1% when the supply voltage varies within ±15% of the rated range | |||
| Insulation Resistance | 50 MΩ minimum, measured with a 500 V direct current megohmmeter between live parts and the housing | |||
| Dielectric Strength | 1000 V alternating current minimum at 50/60 Hz for 1 minute between live parts and the housing | |||
| Vibration Resistance (Destruction) | 10 to 55 Hz; 1.5 mm double amplitude for 1 hour each in the X, Y and Z directions | |||
| Shock Resistance (Destruction) | 500 m/s² double amplitude, 3 times each in the X, Y and Z directions | |||
| Degree Of Protection | IP67 | |||
| Connection Method | Pre-wired (standard cable length: 2 m) | |||
| Housing Material | Case: Acrylonitrile butadiene styrene | |||
Dimension
Wiring Diagram
